Service area · Perth
Concreters in Swanbourne
Swanbourne · Standard grey, non skid finish
A sloping driveway, ripped out and replaced
Someone had coated this Swanbourne driveway red at some point, and the coating had worn through to bare concrete in patches. We ripped the lot out and poured it again in standard grey with a non skid finish, from the street up the slope to the carport under the house and along the side.
Pour day
The photos show it going in. With the old slab gone, we set the formwork along both edges and laid steel reinforcing mesh over the sand base. The mesh sits up on plastic bar chairs, which hold it inside the slab once the concrete is in. The mesh runs the full length, from the footpath right up to the carport, so no part of this driveway was poured without steel in it.
The concrete came in through a pump line from the street, so nobody had to run barrows up the slope. We started at the street end and worked up towards the house: placing it, raking it out, screeding it level with the forms, then edging it along the footpath so the new slab meets the path with a clean rounded edge. We had two concrete trucks on the street out front at once, so if your street is narrow, it is worth knowing that the trucks and the pump need room at the kerb.
Sand under the slab
Swanbourne sits on the old coastal dunes, and you can see the pale sand under the mesh in the pour day photo. Most blocks here are sand over limestone, and this house sits on a base of cut limestone block. Sand makes a good base once you compact it. Left loose, it settles, the slab loses its support and it cracks.
Non skid on a slope
A smooth finish on a sloping driveway turns slippery in the wet, for shoes and for tyres. This one has a non skid finish from the crossover to the carport, so it grips all year round. For paths and entries, see our guide to concrete pathways.
Plain grey this time
The old driveway’s problem was its coating, and standard grey has none for tyres to wear through. The joints cut across the slope control where it cracks. On a driveway that takes cars every day, grey concrete gives you less to look after. The before and after photos are taken from the same spot on the street.
Replacing a driveway in Swanbourne
Swanbourne is in the City of Nedlands, and a new crossover, the part of the driveway across the verge, needs the City’s approval before it is built. On this job the new slab stops at the existing footpath, edged where the two meet, and the footpath stayed as it was. You can see that edge in the pour day photos.
Most Swanbourne homes have had their driveway for decades. A worn coating, cracks running across it, a surface that has gone slippery: any of those is worth a look. Our concrete driveways page shows what else we pour. Call Regan on 0433 510 118 or send through the details and we will come and have a look.
Before and after
Here is what replacing something that has had its day looks like.
A tired old driveway, its red coating worn through to the concrete, ripped out and replaced in standard grey with a non skid finish, poured over steel mesh with the concrete pumped in from the street, from the street up the slope to the carport and along the side of the house
More from Swanbourne
Got a job in Swanbourne?
Ring Regan and he will come and look at it. Rough measurements and a photo help.