Service area · Perth
Concreters in Joondanna
Joondanna · Limecrete Amber White exposed aggregate
Four units, one exposed aggregate finish
We poured the driveways for this new four unit development in Joondanna in exposed aggregate, Limecrete Amber White: the driveways at the street front, and the long shared run down the side of the block to the units at the back. More of Joondanna’s older blocks are going this way, one house making room for units or townhouses.
From the street to the back of the block
At the street, the front units each have their own driveway, side by side. Behind them, the long shared driveway runs down the side of the block and opens out at the back in front of the rear garages. Every car for the rear units turns in and out there, all day. We poured it as one continuous surface and cut joints across it to control where it cracks.
Stormwater in the slab
Four roofs on one block means a lot of water and very little lawn to take it. We set the stormwater grates into the driveway itself, and you can see one in the photos. Rain that lands on the concrete drains away instead of pooling against the garage doors. The grates, and the falls that carry water to them, get set out before the pour, because nobody can move them once the concrete is down. Our guide to driveway drainage goes into more detail.
Amber White up close
From the street, Amber White reads as one pale surface. The close up photo shows what it is made of: small stones in grey, charcoal, brown and amber, with a few white ones, set in a pale cream concrete. That mix of colours hides dust and tyre marks better than one flat colour would. If you are choosing a mix, look at a finished driveway like this one rather than a sample the size of your hand.
Why Amber White
Amber White sits at the pale end of the exposed aggregate range. Across this much driveway it keeps the development light and suits the white render. A dark mix would read as one long dark strip down the block. Pale stone also soaks up less summer sun, which matters when the driveway doubles as everyone’s path to the front door.
The crossover and the City of Stirling
Joondanna is in the City of Stirling, and the crossover, the part of the driveway that runs across the verge from the kerb to your boundary, sits on the City’s land. You need the City’s approval before it is poured. Pour one without approval and you may have to rip it out if it does not meet the City’s crossover guidelines.
A few of those rules shape a unit development. A shared crossover for a duplex or multi residential block can be 3 to 7.5 metres wide, at least half a metre in from the neighbour’s boundary, and one to three metres clear of a street tree depending on how thick the trunk is. Exposed aggregate is allowed on the crossover if the concrete meets the Australian Standard, AS 1379. Where a footpath crosses the driveway, the City wants the path to show through it, usually as a strip of plain grey, so the stone finish stops either side. If your street has no footpath yet, the City aims to have one on every street by 2031, and when it builds yours it will replace the first 2.05 metres of your crossover with plain grey.
Building units in Joondanna?
If you are building units or townhouses in Joondanna, or replacing an old driveway, our concrete driveways page shows the other finishes we pour. Call Regan on 0433 510 118 or send through the details and we will come and have a look.
More from Joondanna
Got a job in Joondanna?
Ring Regan and he will come and look at it. Rough measurements and a photo help.